Skip to content

Relay messages manually

Attention

Axelar relayers process XRP and Interchain Token Service transfers between the XRP Ledger and the XRPL EVM Sidechain automatically, on both Mainnet and Testnet. Manual relaying is only needed to recover a message that was not delivered.

Transfers and messages between the XRP Ledger and the XRPL EVM Sidechain go through the Axelar Amplifier Gateway on each chain. Axelar relayers pick up the source transaction, get it verified by the Axelar network, approve it on the destination gateway and execute it on the destination chain. For XRP and Interchain Token Service (ITS) transfers, and for General Message Passing calls that paid enough gas, this happens without any action from you.

Tracking a transfer or message

Search for the source transaction hash on Axelarscan to see each step (called, confirmed, approved, executed):

When a message is not delivered

If a message stays in an intermediate status:

  • Not approved: the source transaction usually did not pay enough gas. Check the gas status on Axelarscan and add gas if needed. Estimate the fee with the Axelarscan API (POST https://api.axelarscan.io/gmp/estimateITSFee for ITS transfers, POST https://api.axelarscan.io/gmp/estimateGasFee for GMP calls).
  • Approved but not executed: you can execute it yourself by calling execute on the destination contract with the commandId, source chain, source address and payload, as shown in General Message Passing.

For the underlying commands, see Axelar's XRPL integration guide.